In other words, water runs from your faucet into the sink, down the drains, into a pipe that leads into the main line.-Another solution is to use a powerful stream of water from a hose to break open the debris clogging the space.-First, locate the main line’s opening, which is usually on the lowest floor of the home.

https://www.betterdrain.cn/product/linear-drains/

It is possible to clean out and open up these systems, but to do so you will need to know a few helpful tips and methods for doing so. There may be a plug on the floor or a metal top to the opening.The main drain is often a job for drain cleaning professionals to repair. It can prevent any problems from occurring.-After it is complete, replace the cap properly. If you do wish to do so yourself you should consider the following. -In some cases, these are in pantries or garages rather than in the open area of the home, especially when there is no basement.Professional drain cleaning is by far the best solution. If you do want to try this on your own, do so with care. These professionals can also tell you what caused the clog to occur in the first place.-It is possible to use a plumber’s snake in this line as long as you do so carefully.-Insert the auger into the line in both directions since it will be impossible to tell where the problem is. Be careful not to use too much pressure (avoid using brass sink drain assembly pressure washers, for example) due to risk of breaking the line. Drain cleaning by a professional is by far the best way to open this up. Most of the time these are vertical pipes but they can be horizontal in some cases. All of the other pipes in the home lead to the main lines. Remove the fittings on the plastic or steel cap with a wrench.. Unclogging the Main DrainsThe main drains in a home are those that run from the home outward.-Grab a bucket to place under or at the opening before you open it up since debris and material China floor drains can be right at that location. Do not allow the edges of the pipe to encounter the snake. When a large clog happens and the initial pipes are not the problem, it could be a clog in the main lines. Be thorough about running it. The main system and lines are some of the largest but they also collect the most material around the edges of them, which leads to more frequent clogging when they are not receiving regular cleanings. In some cases, it can be in very tight due to not being opened often. -Do not force it to open

コメント